Now that the weather is nice enough for us northfags, what have you done recently to your cars?
>Pic related
Got the controls arms, springs, and drive/half shalfts sandblasted and powedercoated.
Now that the weather is nice enough for us northfags, what have you done recently to your cars?
>Pic related
Got the controls arms, springs, and drive/half shalfts sandblasted and powedercoated.
Other urls found in this thread:
While not northern, I installed flaps on my car earlier this week.
>Replace Intake Manifold
>Replaced all four rotors, break pads, and calipers
>replaced egr gasket
>replaced two smoke tire rods
>currently trying to find out why engine stutters with ETC light on at low idle RPM's. Think it's throttle body assembly or a vacuum leak
>Washed + Cleaned interior.
Seriously, fuck snow and sand.
>Pulled Intake and throttlebody off
>Cleaned MAF
>Cleaned TB (Drive by wire, fite me faggot)
>Oil change
>vacuumed interior
>Stripped and resealed the paint because Midwest
>Interior White LED swap because I like being able to see in my car
>LED License plate light swap
Fun stuff
Let me guess early generation corvette?
install my exhaust
>Decided I'd do ball joints
>Driver side went pretty smooth despite the fact the rust had pretty much turned it into a solid unit
>Halfway through removing the passenger side upper and it had actually turned into a solid unit
>Need a new upper control arm because of rust
Fuck this rust belt bullshit.
tail lights
>thumbnail
Nice Mustang.
Nice fr s
I've been loving that style of aftermarket taillights on the frs/gt86/brz
Yeah a C3, I'm curious what gave it away though.
Good job OP, that is going to look nice for all of about 10 seconds.
New chrome shorty headers and an x-pipe
I got myself one of these for the AW11 I don't own yet. Insurance against the shitty three spoke steering wheels
How easy is doing headers on a 5.0 without pulling the motor?
>Riven
die.
Very easy. Took two people. Total install time accounting for food break was 8.5 hours. I could do it much faster now that I know what I'm doing though.
Interesting, I want to get a 5.0 of my own some day and do a bunch of bolt on mods. That's a bbk shorty, right? Also, why are all the wires out?
Currently replacing everything that isn't the body or the glass.
Headers won't go on with wires in place.
oh now i see i feel silly
I put the blc slap on, and now my rod bearings are migrating into my oil at a pretty fast pace.
still need to pull the pan and see if i can get away with bearings alone.
tfw my I4 sounds like an H4 with unequal length headers
was about to say the same