Help Removing Rotor

that thing sucks.

I stripped two of them trying to pull a crank off. shit quality, shit material, threads are made from butter.

Heat and a hammer.

Or you hit it with a hammer rather than spend $20, you dense cunt.

Use more WD40
Hit with hammer
If that doesn't work, get your oxy out and get it hot
Now hit with a hammer

I'm not Jeremy Clarkson. It might work, but why risk damaging something else?

>working on a car with no tools

Maybe, but there's a lot more force needed in pulling a crank, this is just a disc brake and it works well at least for that. I don't think OP has the knowhow to work on something that needs that much force, or will be using it a lot.

>spending $20 on a cheap gear puller is stupid
>now just get out your ~$100 oxy torch

Nigger, you're an order of magnitude more likely to have an oxy than some fucking clamp+screw arrangement shit.

It's not going to damage anything (the puller might though because you would have to put it on the braking surface or in the slots if it's a vented rotor on the far outside of the rotor where it's most susceptible to leverage warping it). I've never in my life seen someone use a puller to get a rotor or drum off, a torch and a hammer is the correct tool for the job.

Why are buyfags so stupid?

>puller might damage rotor
Who cares? It's being replaced.
>I've never seen someone use a gear puller to remove a brake rotor
Should have been at my house this past weekend, did it myself, shit worked like magic.