Rate my setup

Rate my setup.

looks solid desu

wouldwatchfortheratseatingthebenchthough/10

Every suburban father of unsuccessful adult children's back yard ever/10

This is my house though. I live alone.

So where are your kids at? Do you have at least one deflated ball for the sport you tried to get your son into but he dropped out of in less than two months?

I don't have kids.
Turn your projector off.

you sure are a lot of fun OP

7/10

why the 2 screwdrivers?

To put on the squat rack. I lost the pins.

kek

Wew

Is that safe

Of course. I haven't tried it without the pins yet, because I only lost them recently but I'll be fine.

Not my son, my wife's son. But either way, don't ever talk to me or him ever again.

Frig off

God that was well memed

Bretty gud for being on a budget
Why is it not in that shed behind it though?

That looks a lot like that retards durianriders setup.

That description is eerily similar to my cousin's situation

It's a means to an end. As long as it gets the job done then it doesn't matter.

Too small. Also use it to hotbox with buddy's once in awhile.

>all the plates stacked on one side
>no barbell
Fucking hulk here uses his pinkies to bench

It's just convenient and faster to have my pl8s on one side.
My barbell is out of frame, I moved it to do military press and I just haven't moved it back.

You're kidding right?

About the barbell or plate thing?

Oh my God

OP seriously get a safer setup, I don't want to hear about you on the news

Once the Jew's decide I deserve more money I'll get right on that.

Has potential to be a very comfy gym, but at the moment it's a deathtrap/10

I've also been using this set for about 2 years now. I haven't hurt myself except when I had to go outside at night to put the tarp over it because the rain. Stubbed my toe on 45 I left on the ground.

Deathtrap how?

Plates are unbalanced, potential tip hazard, possible death. No spot bars, potential death. Unknown amount of rust corrosion, potential collapse, possible death.

Check craigslist every day. Can get a decent power rack with spot bars and a bench for cheap if you're lucky. But seriously at least even out your weights and find something better for spot bars or have a spotter on bench days.

I'm no design engineer user, but those screwdrivers make me uneasy. The rust damage is another pretty cause for concern.

Either way, good luck and stay safe.

I don't see this as a deathtrap

How in the fuck is my entire bench going to tip to one side?
The rust is manageable. Barely any on them. Relatively new actually.

Did you fail geometry?

Those are just to hold the squat rack, no big deal. They don't hold the actual weight of the barbell for very long.

With me on it, doing bench, there is no way it could tip.

Some duct tape with make that bench good as new.